Sending til:
Ísland

MB4046 Beard Kit - Skeggsnyrtir

10.579 kr
Stærð
  • Afhending 2-3 virkir dagar*
    Hröð afhending - Sendingarkostnaður frá 1.590 kr
  • Auðveld skil
    Auðveld skil 30 daga
Um vöruna
  • Spenna (Vött): 0.9 w
Upplýsingar um vöru
Það er komið að því, skeggðin er komin til að vera. Þessi ómissandi stíllvara fyrir nútíma karla og krefjandi herramenn alls staðar að getur nú verið fínstillt til fullkomnunar með Remington skeggjasettinu. Vegna þess að hvert skegg er ólíkt inniheldur þetta háþróaða sett úrval af 3 greiðum til að tryggja algjöra fjölhæfni við að snyrta og móta andlitshárin þín. Hannaður fyrir styrk og framúrskarandi skurðframmistöðu inniheldur rakvélin í Remington skeggjasettinu títan-húðaðar, sjálfbeittandi blöð – hágæða fyrir langvarandi niðurstöður. - títan-húðuð blöð - sjálfbeittandi blöð - pop-up rakvél – fyrir nákvæma snyrtingu - XL stillanlegur kammi (20-35 mm) - stuttur stillanlegur kamur (1,5-18 mm) - stubblekamur (1-5 mm) - allt að 90 mínútna raflaus notkun - 4 klukkustunda hleðslutími - með og án snúru - skeggbursti úr blandaðri svínahárshnúa - hágæða ryðfríu stáli skæri - hleðsluvísir - 3 ára ábyrgð
Hvernig skal nota:
• cordless use – when the product is switched on and fully charged it can be used in cordless mode for up to 90 minutes. • switch the product on by sliding up the on/off switch. • always comb your beard or moustache with a fine comb before you start trimming. • if you wish to trim your beard hair between 1.5-18mm – attach the short length adjustable comb. • for maintaining and trimming longer beard length between 20-35mm attach the xl adjustable comb. • to attach a comb, first ensure the adjustable zoom wheel is set to 1. then slide on the desired comb so that the comb rails align into the slots found at the top of the trimmer head. • select the comb length by rotating the zoom wheel upwards to increase the length and downwards to decrease the length. please see the table below for the different length increments. setting -> hair trimming length with short length adjustable comb attached 1->1.5mm (grade 0) 2-> 2.5mm (grade 1) 3-> 4mm 4 5.5mm (grade 2) 5-> 7mm 6-> 9mm (grade 3) 7-> 11mm (grade 4) 8-> 14mm (grade 5) 9 ->18mm (grade 6) setting -> hair trimming length with xl adjustable comb attached 1-> 20mm 2 ->21mm 3 ->22mm (grade 7) 4-> 23.5mm 5 ->25.5mm (grade 8) 6 ->27.5mm 7 ->29.5mm 8-> 32mm 9-> 35mm to remove the comb, with the adjustable zoom wheel set to 1, pull the comb off the beard trimmer. • for a more detailed, precision stubble look, attached the adjustable stubble comb which can trim hair between 1 to 5mm. the cutting lengths increase in 0.5 increments. • please note that the adjustable zoom wheel does not increase the length settings on the stubble comb. to adjust these length settings, turn the dial found on the back of the stubble comb which will then indicate the different trimming lengths to choose from. • note: the below instructions are recommended for those with or wanting to trim beard hair between 1.5 to 18mm in length. to thin and taper the beard/moustache • turn the unit on. • place the flat top of the trimmer comb against the skin. • slowly slide the trimmer through the hair. repeat from different directions as necessary. • if hair builds up in the trimmer comb during the trimming process, switch the unit off, pull off the comb and brush off. detailing • to create sharp lines around your beard, press the pop-up trimmer release button. • start with the edge of the beard/moustache line and gently lower the trimmer blade onto your skin. use motions towards the edge of the beard/moustache line to trim to the desired locations in the facial area and away from beard in neck area. trimming and styling longer beards • to take out volume from your beard or if you want to take down the length significantly, select your desired length setting on the xl comb (please see the table for trimming length settings). place the flat top of the trimmer comb against the skin. slowly slide through the hair. repeat from different directions as necessary. • if hair builds up in the trimmer comb during the trimming process, switch the unit off, pull off the comb and brush the hair off. how to blend/taper your beard • tapering is when you fade the length of your beard from shorter sideburns to a longer beard. this is how you can truly stlye your beard based on different lengths and shapes. 1. adjust the comb to your selected grade. 2. grade settings and the respective trimming lengths the beard kit offers can be seen in the table. you will either need to use the short length adjustable comb or the xl adjustable comb depending on the grade you require. if you don’t know, you can start at a longer trimming setting and work up towards your hairline, lowering the grade number as you go. 3. beard hairs sit on your face much lower than at the root compared to stubble. therefore, use a comb to lift up the hair you want to remove and identify where the root is. this section of hair should be located at the middle of your ear. • start grading your beard here, upwards. don’t start clipping too low or you are going to be taking away supporting hairs lower down. clipping 1. lift this section of hair, guide into the adjustable comb and run the clipper through. go over a couple of times. 2. now it’s time to blend. lower the grade setting on your trimmer to move onto the next higher section of hair (eg. grade 4 to 3). go slightly higher than previous section working upwards. again, place hair into the comb and run the clipper through. 3. repeat process (eg. grade 3 to 2) - this is fading. keep moving the process upwards until you match the grade number on the sides of your head . 4. trim any protruding hairs with the enclosed scissors. 5. brush beard through beard with the enclosed beard brush. 6. add your choice of beard oil/beard wax to your beard. 7. you’re now beard ready to continue to live that bearded lifestyle! trimming edge of sideburns • hold the trimmer with the trimmer blade facing you. • start with edge of sideburn and with the trimmer blades resting lightly against your skin, use motions towards edge of sideburn line to trim to desired locations in facial area. • shape as desired. trimming the nape of your neck • you will need a hand mirror for this operation if performing it alone. • use your fingers to lift the hair at the base of your head up off the neck. your index finger should be covering the roots of the hairs you are lifting to prevent accidental removal by trimmer. • using your other hand, hold the trimmer to the base of your neck with the cutting unit facing up, and move the trimmer up the length of the neck until it touches your finger covering the hair roots at the base of your head. • be sure to move the unit slowly when performing this operation and to keep the hair roots at the base of your head out of the way of the trimmer. tips for best results • beard, moustache and sideburn hairs should be dry. • always brush your beard before beginning to trim, shape or style it. • avoid using lotions before using your trimmer. • if you are trimming for the first time start with the maximum comb length setting. attaching and removing the blade • to remove the blade press the release button found at the top of the trimmer where it meets the back of the blade head and push the blade cartridge upwards and away from the trimmer. • to attach a blade, snap the desired cartridge in place until it clicks.
Upplýsingar um framleiðanda
  • Framleiðandi: Spectrum Brands (UK) Limited
  • Póstfang: Regent Mill, Fir Street, Failsworth, Manchester; M35 0HS, United Kingdom
  • Rafrænt heimilisfang: Colin.Williamson@eu.spectrumbrands.com
Boozt er viðurkenndur söluaðili Remington
Vörunúmer:213090186 - 5038061112467
SKU:ING43285560100
Auðkenni:28093476
Efni: plast, málmur, electricity
Hröð og einföld afhending
Gildir fyrir pantanir yfir 1500 kr Pakkinn þinn kemur eftir 2-3 virka daga á afhendingarstað eða heim til þín.Sýna fleira
Einföld skil á gjöfum
Skráðu þig inn á My Boozt og búðu til gjafakvittun.Sýna fleira
Einföld skil
Allar snyrtivörur afhendast innsiglaðar. Af heilsu- og hreinlætisástæðum er ekki hægt að skila vörum ef innsigli hefur verið rofið af viðskiptavin.Sýna fleira
Kynntu þér fleira
Finndu fljótt svör við spurningum þínum á þjónustusíðum okkar.Þjónustuver og algengar spurningar